Zippy R2G-6350P - Manual (Page 20)

D) Replace a new Good power module, insert the power module into the power
system to the end.
E) Check the LED of the power module light Green.
F) Check the LED which indicates the total power system status, that should be
from twinkle to Green.
G) Tighten the screws of the power module to fix it.
H) If you want to test this new power module in simulating defective situation.
Please refer to the Section 1.8 Installation & Testing Section.
Remarks: If the DC fan of the power module fail, you have to replace the power
module. Please follow with the Hot-Swap procedures of the power module.
1.10 PINOUTS AND FUNCTION OF THE CONNECTORS
*** Please be aware of the polarity***
THE LED CONNECTOR OF POWER#1 (300W ONLY)
PIN# COLOR VOLTAGE
1 GREEN +5V
2 BLACK GND
THE LED CONNECTOR OF POWER#2 (300W ONLY)
PIN# COLOR VOLTAGE
1 ORANGE +5V
2 BLACK GND
THE POWER SIGNAL CONNECTOR OF TOTAL POWER (300W ONLY)
PIN# COLOR CONDITION
1 RED POWER FAIL
2 BLACK GND
3 GREEN POWER OK