beautypg.com

9 hot swap procedures – Zippy R2T-6460P User Manual

Page 21

background image

If everything works out fine, then turn off (remote off) the power system, now put
back the cover of the case and tighten with the screws which you have retained
earlier. Now you have completed the installation of the MR3 / R3U / R2T
redundant power supply system.

1.9 HOT SWAP PROCEDURES

Please refer to the following when one power module found defective.

A) Locate the defective power module by examining the individual LED (if LED

without light, it indicates the power module is defective).



***WARNING:

Please perform the above step carefully otherwise it may cause shut down the
whole system.


***WARNING:

Please do not remove the defective power module until you have worn gloves to
keep from be burned. This is due to the cover of
the power module is been used as
heat sink for cooling, usually the temperature is around 50 ~ 60 degree Celsius
under full
load condition.

B) Loosen the bracket screws which hold the power modules
C) Remove the defective power module by pulling out method


***WARNING:

Please put aside the power module await for cooling down. Keep from other
people tough it until it is cool.

D) Replace a new Good power module, insert the power module into the power

system to the end.

This manual is related to the following products: