beautypg.com

Zippy DMRW-6400F User Manual

Page 9

background image

1.7 INSTALLATION & TESTING

Mount the power supply into the system chassis by using proper mounting tool. The

mounting holes of the power supply should match up with those in the chassis.

Connect the power connectors to the M/B by following the M/B instruction. There is

various on connectors / pinouts in both power supply and M/B. Please ensure to

connect the matched one; otherwise, it will cause une xpected harms.

Connect the remaining power connectors to the various peripherals as needed. These

connectors are “keyed”, so there will be only one possible way to connect them.

Before applying power source to the system, make sure these is no loosed or

incorrect connectors. Double check if all connection to the M/B is matched properly.

Maybe you would like to test the redundancy function before you put back the cover of

your system chassis, then, please power it on. If the power system operates normally,

the individual LEDs on power module and the external warning LED light in GREEN.

Now, remove one power module from the power system, the warning buzzer in the

power system will sound, the external warning LED, which displays the status of the

total power system, will change to be RED, the individual LED indicating the power

module’s status will distinguish. Meanwhile, the power system will continue to backup

the power output without affecting the operation of your computing system.

The warming buzzer will sound continuously. You can reset warning buzzer by

pressing the buzzer reset switch. Insert the power module which is removed for test

earlier. The sound of the warning buzzer will stop; the external warning LED will turn

to be GREEN again; the LED indicating the status of power module will light in

GREEN. Test another power supply by performing the same procedure.

If everything works out fine, then turn off the power system. Now put back the cover of

the chassis and tighten with the screws which you have retained earlier. Now you

have completed the installation of DMRW series redundant power supply.

This manual is related to the following products: