Zippy DMRW-6400F - Manual (Page 8)

INPUT CHARACTERISTICS: DMRW-6400F
l VOLTAGE DC 40V 72V
l INPUT CURRENT 12.0A (RMS) FOR 48 VDC
l INRUSH CURRENT 20.0A MAX.
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
OUTPUT
VOLTAGE MIN. MAX. PEAK LOAD LINE
RIPPLE &NOISE
MAX. [P-P]
+5V 3A 32A 5% 1% 50mV
-5V 0.1A 0.5A 6% 1% 120mV
+12V 2.5A 25A 10% 1% 120mV
-12V 0.1A 1.2A 10% 1% 150mV
+3.3V 1A 25A 5% 1% 50mV
+5VSB 0.1A 2.0A 5% 1% 50mV
REMARK: TOTAL CURRENT OF +5V AND +3.3V NOT EXCEED 45A
TOTAL OUTPUT POWER MAX 400W
SPECIFICATION:
l TEMPERATURE RANGE OPERATING 10 40
l HOLD UP TIME 1.6mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE
l DIELECTRIC WITHSTAND INPUT/OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
l EFFICIENCY 65% TYPICAL AT FULL LOAD
l POWER GOOD SIGNAL ON DELAY 100mS TO 500mS OFF DELAY 1mS
l OVERLOAD PROTECTION 110%~160%
l OVER VOLTAGE PROTECTION +5V 5.7V 6.6V , +3.3V 3.9V 4.3V, +12V 13V 14.6V
l SHORT CIRCUIT PROTECTION +5V +12V +3.3V
l EMI NOISE FILTER : FCC CLASS A, CISPR22 CLASS A
l SAFETY : UL 60950., TUV EN-60950, IEC 60950
l REMOTE ON/OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL
DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY).
AS LOGIC LEVEL IS LOW
OUTPUTS VOLTAGE WERE ENABLE
AS LOGIC LEVEL IS HIGH OUTPUTS VOLTAGE WERE DISABLE.
l DIMENSION 86*150*185 (H*W*D)mm
l COOLING: TWO 40mm DC FANS (MODULE)
l DC INLET IN EACH MODULE