Zippy HU2-5860V - Manual (Page 7)

- 7 -
MODEL HU2-5860V
A INPUT CHARACTERISTICS
1 VOLTAGE 90 264VAC FULL RANGE
2 FREQUENCY 47 63HZ
3 INPUT CURRENT 13.0A (RMS) FOR 115 VAC 7.0A (RMS) FOR 230 VAC
4 INRUSH CURRENT 20A MAX. FOR 115 VAC 40A MAX. FOR 230 VACAT 25
B OUTPUT CHARACTERISTICS
OUTPUT OUTPUT CURRENT REGULATION OUTPUT RIPPLE &
VOLTAGE MIN. MAX. PEAK. LOAD LINE NOISE MAX. [P-P]
+5V 0.5A 25A 5% 1% 50mV
+12V 2A 60A 5% 1% 120mV
-12V 0A 0.8A 5% 1% 120mV
+3.3V 0.5A 25A 5% 1% 50mV
+5VSB 0.1A 3.5A 5% 1% 50mV
REMARK: THE OUTPUT CURRENT OF 5V & 3.3V NOT EXCEED 40A
C SPECIFICATION
TEMPERATURE RANGE OPERATING 0 50
HOLD UP TIME 16mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE
DIELECTRIC WITHSTAND INPUT/OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
EFFICIENCY typical 81-86% at 25 115V FULL LOAD
POWER GOOD SIGNAL ON DELAY 100mS TO 500mS OFF DELAY 1mS
OVERLOAD PROTECTION 130% +/- 20%
OVER VOLTAGE PROTECTION +5V? 5.8V 6.7V, 3.3V? 3.6V 4.3V, +12V? 13.2V 15V
SHORT CIRCUIT PROTECTION +5V -5V +12V -12V +3.3V
EMI NOISE FILTER : FCC CLASS B , CISPR22 CLASS B
1 SAFETY : UL 60950, CSA UL60950, TUV IEC 60950
1 REMOTE ON/OFF CONTROL
THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL
DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY).
AS LOGIC LEVEL IS LOW OUTPUTS VOLTAGE WERE ENABLE
AS LOGIC LEVEL IS HIGH OUTPUTS VOLTAGE WERE DISABLE.
12 COOLING : ONE 120mm DC FAN
13 DIMENSION 140mm*150mm*86mm (D*W*H)
1 MEET IEC-1000-3-2 CLASS D