Zippy HU2-5860V - Manual (Page 4)

- 4 -
MODEL HU2-5560V
A INPUT CHARACTERISTICS
1 VOLTAGE 90 264VAC FULL RANGE
2 FREQUENCY 47 63HZ
3 INPUT CURRENT 8.0A (RMS) FOR 115 VAC 4.0A (RMS) FOR 230 VAC
4 INRUSH CURRENT 20A MAX. FOR 115 VAC 40A MAX. FOR 230 VAC AT 25
B OUTPUT CHARACTERISTICS
OUTPUT OUTPUT CURRENT REGULATION OUTPUT RIPPLE &
VOLTAGE MIN. MAX. PEAK. LOAD LINE NOISE MAX. [P-P]
+5V 0.5A 22A 5% 1% 50mV
+12V 2A 40A 5% 1% 120mV
-12V 0A 0.8A 5% 1% 120mV
+3.3V 0.5A 22A 5% 1% 50mV
+5VSB 0.1A 3.5A 5% 1% 50mV
REMARK: THE OUTPUT CURRENT OF 5V & 3.3V NOT EXCEED 40A
C SPECIFICATION
1 TEMPERATURE RANGE OPERATING 0 50
2 HOLD UP TIME 16mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE
3 DIELECTRIC WITHSTAND INPUT/OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
4 EFFICIENCY typical 81-85% at 25 115V FULL LOAD
5 POWER GOOD SIGNAL ON DELAY 100mS TO 500mS OFF DELAY 1mS
6 OVERLOAD PROTECTION 150% +/- 20%
7 OVER VOLTAGE PROTECTION +5V 5.8V 6.7V, 3.3V 3.6V 4.3V, +12V 13.2V 15V
8 SHORT CIRCUIT PROTECTION +5V -5V +12V -12V +3.3V
9 EMI NOISE FILTER : FCC CLASS B , CISPR22 CLASS B
10 SAFETY : UL 60950, CSA UL60950, TUV IEC 60950
11 REMOTE ON/OFF CONTROL
THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL
DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY).
AS LOGIC LEVEL IS LOW OUTPUTS VOLTAGE WERE ENABLE
AS LOGIC LEVEL IS HIGH OUTPUTS VOLTAGE WERE DISABLE.
12 COOLING : ONE 120mm DC FAN
13 DIMENSION 140mm*150mm*86mm (D*W*H)
14 MEET IEC-1000-3-2 CLASS D