Zippy DM2W-6500F - Manual (Page 7)

INPUT CHARACTERISTICS: DM1W2-5600V/5650V/5700V
A INPUT CHARACTERISTICS
l
VOLTAGE: -36 ~ -72 VDC, NORMAL -48VDC
l
INPUT CURRENT 16/17/19A RMS FOR -48VDC
l
INRUSH CURRENT 30A AT -48VDC (AT 25 DEGREES AMBIEND COLD START)
B OUTPUT CHARACTERISTICS
OUTPUT OUTPUT CURRENT REGULATION OUTPUT RIPPLE
&
VOLTAGE MIN. MAX. LOAD LINE NOISE MAX. [P-P]
+5V 0.5 32 ±5% ±1% 50mV
+12V 2 45/50/55 ±5% ±1% 120mV
-12V 0.05 0.8 ±10% ±1% 120mV
+3.3V 0.5 36 ±5% ±1% 50mV
+5VSB 0.1 3.5 ±5% ±1% 50mV
REMARK: 1.+5V AND +3.3V TOTAL OUTPU NOT EXCEED 200W
2. TOTAL OUTPUT POWER NOT EXCEED 600W/650W/700W
C SPECIFICATION
1 TEMPERATURE RANGE OPERATING 0 60 STORAGE -20 80
2 HOLD UP TIME 1mS MIN. AT FULL LOAD
3 DIELECTRIC WITHSTAND INPUT/OUTPUT 1500 VAC FOR 1 minute
INPUT TO FRAME GROUND 1500 VAC FOR 1 minute
4 EFFICIENCY 80% TYPICAL AT INPUT -48V FULL LOAD
5 POWER GOOD SIGNAL ON DELAY 100mS TO 500mS OFF DELAY 1mS
6 OVER POWER PROTECTION 110 150% MAX
7 OVER VOLTAGE PROTECTION +5V? 5.7V 6.5V +3.3V? 3.9V 4.3V +12V? 13.3V
14.3V
8 OVER CURRENT PROTECTION:+5V,+12V,+3.3V
9 . EMI : FCC CLASS A , CISPR 22 CLASS A
10 SAFETY TO MEET UL, CUL, TUV
11 . REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL
DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY).
AS LOGIC LEVEL IS LOW OUTPUTS VOLTAGE WERE ENABLE
AS LOGIC LEVEL IS HIGH OUTPUTS VOLTAGE WERE DISABLE.
12. COOLING: TWO 38x38x28mm DC FANS
13 .DC INLET IN EACH MODULE
14. DIMENSION 300(D) X 101.2(W) X 84(H) mm