Workrite Sonoma Series SELECT - Manual (Page 4)

Sonoma Series
™
SELECT Workcenters
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.wrea.com Page 4
ASSEMBLY INSTRUCTIONS
Attach feet to die cast base with 3/4” machine screws.
Note: the long end of the foot extends to the front of the
base. This is the side that faces the user. The rear of the
base is the side with the control pad connector.
Attach Control Pad to the underside front edge of
worksurface using #8 x 1” screws, the holes are
pre-drilled. Plug cable into the connector at the top of
the Column Assembly. Using cord clips, tighten cable
to the underside of worksurface so that cable is not
dangling.
Flip table over and adjust Leveling Guides as required
so that table is steady and does not rock. Plug power
cord into grounded 120 volt outlet. Adjust up or down
by pushing appropriate arrow on Control Pad.
Attach the entire column assembly to the worksurface
with the #12 x 3/4” wood screws provided. Use the
locating holes provided. If this
is a base-only
unit and the
surface does not
have locating holes,
it is best if pilot holes
are drilled for the
screws.
STEP 5
STEP 7 STEP 8
STEP 6
Rear
Control Pad
connector
Plug Control
Panel connector
into this connector
long side