Workrite Sonoma Series SELECT - Manual (Page 3)

Sonoma Series
™
SELECT Workcenters
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.wrea.com Page 3
ASSEMBLY INSTRUCTIONS
Place Column Assembly on floor with the
black top bracket facing down.
Attach one half of Die Cast Base to bottom plate with
3/8” button head machine screws, do not fully tighten
screws. Fit the power cord and strain relief into round
slot between the base halves. Attach other half of Base
to bottom plate. Slide Support Frame so that it fits
snuggly into gap between base and column. Tighten
all screws.
Slide Support Frame onto column as shown.
STEP 1
STEP 3
STEP 2
Insert plastic Foot Caps into the ends of each foot.
Screw Leveling Guides into bottom of each foot.
STEP 4
OPEN ALL PACKAGES AND VERIFY THAT YOU HAVE ALL THE HARDWARE AS INDICATED IN THE PARTS LISTING.
To assemble you will need a #2 and #3 tip Philips screwdriver.
Strain Relief
Support Frame