Workrite Sierra HX Pin Assembly Instructions for 2-Leg Pin models - Manual (Page 3)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 3
Workrite Sierra HX™ 2-Leg Pin Workcenters - Assembly Instructions
d
To avoid stripping the threads,
always insert and make the
first few turns of the screw BY
HAND with an Allen wrench,
ensuring it is in straight.
a
c
d
b
24" deep or less
more than 24" deep
With legs on their sides, attach Long Brace (B) to top of both Legs using Button Head Screws
(J). The Brace should have the lip on top, facing away from the leg. Do not tighten screws
completely.
b
2
Assemble Legs
Attach one Leg Cap (F) to the top of each Leg (D) using Button Head Screws (G). Do not tighten
screws completely.
a
Turn Leg Assembly upside down and attach both Short Braces (C) using Button Head Screws (J).
Do not tighten screws completely.
c
Attach Medium Braces (E) to sides of Legs using Button Head Screws (J). If you have a 24” deep or
less worksurface, use the holes towards the back of the brace so that the brace extends out above
the long part of the foot. For deeper worksurfaces, use the center holes of the brace so that it is
centered on the leg. Do not tighten screws completely.
d
D
F
G
B
I
J
J
C
J
E