Workrite Sierra Modesty Panel - Manual (Page 3)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 3
Sierra TM Modesty Panel - Assembly Instructions
3
Attach C-Clips to Underside of Worksurface
Determine where you want to position the Modesty Panel under your worksurface. Any location in
front of the legs where it will fit is okay.
Using one of the Aluminum Rods, with three C-Clips attached as a guide, mark with a pencil where
the holes for the C-Clips should be. They should be evenly spaced along the rod.
Drill pilot holes into the worksurface, then attach the C-Clips using the proper screws for your
worksurface type.
a
2
Unroll the Modesty Panel
Remove the Aluminum Tubes from inside the cardboard tube containing the rolled up Modesty
Panel, then carefully unroll the panel. DO NOT fold or crease the fabric, this will leave permanent
marks.
Important Note
If you have a Silhouette Top, you will need the special Drill Kit for Silhouette Tops.
If you use a regular drill bit, you will damage your worksurface. To order your Drill
Kit, call Customer Service and ask for part #4400303 (the “Silhouette Drill Kit”).
c
b
b
c
D
C
B
OR