Workrite Sierra HXL Electric Assembly Instructions for 2-leg Electric Workcenters - Manual (Page 6)

6 of 8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables
Attach Switch
If you have a Workrite worksurface:
Position the switch over the pilot holes near front
edge of worksurface.
If you do not have a Workrite worksurface:
For non-Workrite worksurfaces, align Switch (N)
so that outermost edge of switch is flush with
edge of worksurface. Pre-drill screw pilot holes
into underside of worksurface with 3 ⁄
32
” drill bit.
You may wish to mark your drill bit so you do not
drill any more than ¾” deep and damage your
worksurface top.
Do not drill all the way through
worksurface!
Attach Switch (N) to underside of worksurface
using the smaller (#8 × ⅝”) Pan Head Screws
(L). You may have purchased the Standard
Control which attaches in the same fashion.
front
N
L
b
7
a
b
Attach Control Box to Tabletop
Position Control Box (P).
If you have a Workrite tabletop:
Locate the four pilot holes for the Control Box and
proceed to Step b .
If you do not have a Workrite tabletop:
Place Control Box (P) in position and use a pencil to
mark pilot hole placement. Control Box should be placed
towards rear center of tabletop. Lay out Switch (N) and
Leg Cables (O) to be sure they all reach the Control Box.
Remove Control Box and drill pilot holes where marked.
Do not drill all the way through tabletop!
With Control Box positioned over pilot holes, attach with
four Pan Head Screws (K) as shown.
P
K
O
O
N
6
a
b
b
a P