Bosch SHE55C - Manual (Page 9)

9
Top Rack Accessories
Top Rack Flip Tines
flip tines fold down to make loading the racks easier in some instances. Grasp the tines,
release from notch, and fold the tines downward. When the top rack is loaded, push it into
the dishwasher.
NOTE: When pushing the top rack into the dishwasher, push it until it stops against the back
of the tub so the top rack spray arm will connect to the water supply. Do not push the top
rack with the door.
RACKMATIC™ Top Rack Height Adjustment
The top rack can be raised to accommodate items up to 8” (20cm) in the top rack and 14”
(36cm) in the bottom rack, or lowered to accommodate items up to 10” (25cm) in the top
rack and 12” (30cm) in the bottom rack. (See Figure 4 & 5)
NOTE: Before you push the top rack back into the dish-washer, ensure that the rack height
is the same on both sides. Otherwise, the dishwasher door will not shut and the top rack
spray arm will not connect to the water circuit.
e) Push the top rack back into the dishwasher.
Loading the Bottom Rack
place large items in the bottom rack. load pots, pans and bowls upside-down. figures 6 and
7 show typical mixed loads for the bottom rack.
Bottom Rack Flip Tines
flip tines fold down to make loading the racks easier in some instances. Grasp the tines and
fold them downward.
Loading Extra Tall Items
if an item is too tall to be placed into the bottom rack even with the top rack in the raised
position, remove the empty top rack by pulling it out of the dishwasher until it stops rolling.
pull the front of the rack upward and outward until the rollers are completely free of the
roller guides. set the top rack aside. push the roller guides back into the dishwasher. insert
the extra tall item sprinkler into the top rack spray outlet and turn the sprinkler clockwise to
lock it into position as shown in figure 8. place your extra tall item(s) in the bottom rack as
shown in figure 9.
NOTE: Keep the vent on the tub’s right side clear by placing tall items such as plastic cutting
boards and tall baking sheets on the bottom rack’s left side, center, or back.
NOTICE
To avoid dishwasher damage, do not reinstall the top rack without removing the extra
tall item sprinkler. Do not reinstall the top rack with the sprinkler installed.
to remove the sprinkler and return the dishwasher to its normal condition:
1. turn the sprinkler counterclockwise and remove it.
2. retrieve the top rack.
3. tilt the top rack upwards and position the top rack rollers onto the roller guides.
4. Continue pushing the top rack until the rollers are on the guide.
5. push the top rack into the dishwasher.
Loading the Silverware Basket
NOTE: the silverware basket tops can be folded up to accommodate large or oddly-shaped
items.
Figure 6
Figure 7
Figure 9
Do not block vent.
Figure 8
10 place setting bottom rack
12 place setting bottom rack