Bosch SHE55C - Manual (Page 15)

15
To remove the top spray arm:
1. remove the empty top rack from the dishwasher.
2. turn the rack upside-down. the top spray arm is held in position by a locking nut as
shown in figure 24a. turn the locking nut counter-clockwise 1/8 turn and remove it,
as shown in figure 24B to release the spray arm.
3. remove the spray arm as shown in figure 25.
4. look for obstruction in the spray nozzles.
5. If the spray nozzles need cleaning, flush them under running water.
To reinstall the top spray arm:
1. return the top spray arm to its installed position.
2. return the locking nut to its installed position and turn it 1/8 turn clockwise.
3. return the top rack to the top rack roller guides.
To remove the bottom spray arm:
1. remove the empty bottom rack from the dishwasher tub.
2. Grasp and lift the bottom spray arm as shown in figure 26.
3. look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, flush them under running water.
To reinstall the bottom spray arm:
1. return the bottom spray arm to its installed position and press it so that it snaps into
place.
2. return the bottom rack to its installed position.
Check/Clean the Filter System
This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter. Select models have an additional Micro Filter. The filter system is located on
the inside of your dishwasher under the lower rack and is easily accessible.
During normal use, the filter system is self-cleaning. You should occasionally inspect it for
foreign objects and clean it when necessary.
CAUTION
To avoid injury, do not reach into the large object trap with your fingers. The large object
trap could contain sharp objects.
This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter. The filter system is located on the inside of your dishwasher under the lower
rack and is easily accessible.
During normal use, the filter system is self-cleaning. You should occasionally inspect it for
foreign objects and clean it when necessary.
To Remove the Large Object Trap/Cylinder Filter Assembly:
1. remove the bottom rack.
2. Grasp the assemblyas shown in figure 27 and turn it counterclockwise 1/4 turn.
3. lift out the assembly as shown in figure 28.
4. Carefully examine the assembly. If you find debris in the Large Object Trap, turn it upside-
down and gently tap it on a surface such as a countertop to dislodge and remove the
debris. flush the Cylinder filter clean by holding it under running water.
Figure 24
Figure 25
Figure 26
A
B