3 pumping off the collected fluid, 4 deflating and packing – Vetter Pneum. collection tubs 0.3 bar User Manual
Page 5

Seite 4/7
Drive the defective truck onto the collecting tub.
The walls of the pneumatic collecting tub must
remain free and must not be loaded in any way!
Open the pressure regulator and start inflation. Close the hand valve
when the operating pressure is reached.
4.3 Pumping off the collected fluid
To pump off the collected fluid, use a commercially available immer-
sion pump (comply with the resistance), e.g. item no.: 1520041600
dewatering pump. For complete vacuum withdrawal, if necessary the
suction nozzle (Item no.: 1700014701) can be used in combination
with a Vetter aspirator.
4.4 Deflating and Packing
The deflation of the support frame happens over the inflation connec-
tion. To deflate the tub, close the air source (compressed air cylinder,
etc.) and disconnect the pressure reducer. Screw the cap off of the fil-
ling connection in the counter-clockwise direction. The deflation valve
is opened by pressing-in and turning the pin (1) counter clockwise.
1
Pin before locking
Pressing-in + turning
Valve open