Vetter SP 25 - Manual (Page 10)

VETTER Safety cushion SP 25
Page 9/15
For this purpose return the rescue cushion to the manu-
facturer only without the compressed air cylinder!
For reasons of product safety and liability, the service life of the
safety cushion is limited to 15 years. It must not be used thereafter
for exercises or any other purposes.
Test instructions and certificates 5.2
The individual tests, checks and inspections shall be carried out in
accordance with the operating instructions.
The tests, checks and inspections carried out shall be recorded in
a test protocol. (Please make a copy of the page, if required.)
The tests, checks and inspections carried out shall also be recor-
ded permanently in the relevant logbook (included in the scope
of supply) and at the safety cushion itself (type plate).
Packing instructions 6.
Check all VETTER safety cushions before the packing that they are
not damaged in any way.
The compressed-air cylinder must always be filled befo-
re the packing.
Only properly tested, dry and clean safety cushions must be pa-
cked.
Empty the load-bearing frame completely by opening the protec-
tive rubber cap (item 1) of the quick-action ventilating valve and
by pressing the air vent key (item 2) gently into it until the latching
of the key can be felt.
After the bulk of the air mass has escaped, fold up the safety cushi-
on in accordance with the following folding instructions in order
to push out any extra air.
After that, spread the safety cushion out again.
If necessary, repeat this procedure until all the air has escaped
from the cushion.
or:
Suction off any remaining air comoletely out of the support frame
using the vacuum adapter (Art. No. 1600 0163 00).
To do this, latch the vacuum adapter into the deflation valve and
connect to the air supply. Inlet pressure max. 6 bar, optimum 4
bar. If necessary, repeat this sequence before fixing the packing
cover.
1
2