Vetter S.Tec Lifting bags 10 bar (145 psi) - Manual (Page 6)

Vetter S.Tec Bags 10 bar
Page 5/18
2.3 Vetter safety coupling system
a. Input coupling of the controller
Connect the air supply hose or the connection hose of the pres-
sure regulator to the nipple of the input coupling (1) on the cont-
roller pushing the nipple solidly into the coupling until the ratchet
action can be felt. In order to ensure that it is correctly connected:
turn the brass sleeve (2) of the coupling opposite to the safety
pin (3).
b. Inflation hoses
To connect the inflation hoses to the corresponding controller or
to the S.Tec Bag, press the hoses or bag nipple solidly into the cou-
pling until the ratchet action can be felt. The coupling sleeve must
be seated on the support ring without any gap (1). To release the
connection (only in the pressure-free condition) the nipple must
be solidly pressed against the spring pressure in the coupling. At
the same time the coupling sleeve must be pushed back. The cou-
pling then releases.
c. Inflation with an 8 bar inflation device
The S.Tec safety coupling system cannot be used for inflation with
other inflation devices. However, should it be necessary, in excep-
tional cases, to inflate with the Vetter 8 bar system then the
10 bar / 8 bar adapter must be used.
2.4 Product description
Vetter S.Tec Bags are made by hand from high quality raw ma-
terials so that after completion, a seamless bag is produced. The
semi-finished product is vulcanized under the influence of pressu-
re and temperature and by doing this the individual layers bond
to form an elastomer body. After production has been finalized,
each S.Tec Bag is subjected to a plant acceptance test within the
scope of quality assurance.
Material of the S.Tec Bag: CR/Aramide, hot vulcanized
1
2
3
1