Universal Remote Control (URS) MRX-4IR 7.11.14 User Manual
Page 6
MRX-4IR N
ETWORK
B
ASE
S
TATION
Rear Panel
The rear panel ports are:
DC 12V Power: Plug in the included 12V DC 1A power supply.
IR Outputs: Connect an included 3.5mm IR emitter to each of the
four IR outputs. Adjust the IR output signal strength for port 1 using
the attenuator located on the bottom of the unit.
LAN Connection: If a wired connection is needed, this port uses a
standard Ethernet (RJ-45) plug to communicate via the local area
network.
Page 3