Torbal RXP-4 - Manual (Page 4)

3 4
After removing the printer and all of its components from the packaging, connect
the printer to the scale by plugging in the RS232C connector to the printer and
the RS232 connector to the scale. 2.
R232C
(plugs into the printer) RS232
(plugs into the scale)
After connecting the printer to the scale, plug in
the AC adaptor to the AC adaptor socket located
at the rear of the printer. 3.
The printer is now ready to use. To turn the printer
ON, simply press the ON/OFF switch located at the
rear of the printer. When the switch is pressed,
the power indicator located on the front of the
printer will light up, indicating the printer is ON. 4.
To remove paper, press and hold the feed button
located on the top of the printer. The printer will
begin to feed the paper until the feed button is
released. 5.
To print DATA from the scale, please follow your scale's instruction manual.
Model DRX-4C : Chapter 11, page 14 (Printing the Recipe) and Chapter 15,
page 25 (Printing a pill count receipt)
Model DRX-4C2: Chapter 11, page 14 (Printing the Recipe), and Chapter 13,
page 19 (Printing a pill count receipt)
6.
Typical Setup