Symtech Pro Series Kit - Manual (Page 2)

524 S.E. Transport Drive
Lee’s Summit, Missouri 64081
816-525-9263 FAX: 816-525-9283
www.symtechcorp.net
Safety by Design
A
s with any repair versus replacement, some items will not
achieve like new results. If directions are followed, significant
improvement in the appearance of the items will be achieved. As
we are unable to supervise the application process, user assumes all
risks. The manufacturer and its distributors are not liable for any
damages incurred by the use of this product. If you are unsure as
to the application process or compatibility of the item you would
like to resurface, please contact the manufacturer or distributor for
advice on how to proceed.
Manufactured for Symtech Corporation
by Coliance Corporation.
REVISED 10/2008
** NOTE: DO NOT sand Police / Emergency light bar covers
unless absolutely necessary, such as excessive break-
down of plastics. This plastic tends to scratch easily,
if you feel it is needed, use the highest grade sandpa-
per as possible (2000 or 2500 grit). Wet the sand paper
and use a Back and Forth Motion in the same direction.
Before applying Deep Fill Restorer, be sure lens is com-
pletely clean and dry. Use only WATERBASED Pretreat-
ment for this. Look at the lens while the Pretreatment is
wet, this will give you an idea of how the lens will look once
the final step is done, and will also let you know if more
cleaning is needed.
Apply a small amount of DEEP FILL RESTORER to a lint
free paper towel and apply it pressing firmly, starting at the
top of the light and wiping from left to right with firm pressure
so you are pushing it into the plastic. Wipe over the area sec-
ond time with the wet part of the paper towel to remove any
excess. Move down the light in the same manner Do Not go
over a covered area more than twice as this product dries
quickly and will build up leaving the light with a streaked
appearance. Allow to dry completely, if you step back about
3-4 feet from the vehicle, the sand scratches should not be
obvious.
Apply SHINE RESTORER/PROTECTOR with lint free
paper towel and wipe it smoothly over the lens cover as if
painting. Lightly touch up drips and always wait for the coats
to dry before adding the next coat. We recommend at least 3
coats of SHINE RESTORER/PROTECTOR for added
protection.
3.
4.
PAGE 2
NOTES: