Snow Joe 324E-RM Plus 11-Inch 10-Amp Electric Snow Shovel with Light - Manual (Page 7)

Maintenance
If the extension cord is plugged into product, someone could
accidentally operate it while you are performing maintenance
on it, causing serious personal injury.
Disconnect the extension cord before you perform any
maintenance.
Replacing the Rotor
Important: Disconnect the power from the electric snow
shovel before performing this procedure.
1. Use a 9/16-inch wrench to remove the bolt on the side
of the housing.
2. Remove the old rotor from the housing.
3. Install the new rotor in the housing by inserting the
end of the rotor onto the fitted end in the housing and
rotating the rotor until it snaps into position.
Note: The housing will flex when you install the rotor.
4. Tighten the bolt on the side of the housing.
Lubricating the electric snow shovel
The electric snow shovel does not need lubrication; all
bearings are lubricated at the factory for the life of the product.
Double-insulated Appliances
In a double-insulated appliance, two systems of insulation
are provided instead of grounding. No grounding means is
provided on a double-insulated appliance, nor should a means
for grounding be added to the appliance. Servicing a double-
insulated appliance requires extreme care and knowledge of
the system, and should be done only by the qualified service
personnel at your Snow Joe Service Dealer. Replacement parts
for a double-insulated appliance must be identical to the parts
they replace. A double-insulated appliance is marked with the
words “Double Insulation” or “Double Insulated.” The symbol
(square within a square) may also be marked on the appliance.
7
Fig. 8
Fig. 9
Fig. 10
Fig. 11