SleuthGear Xtreme Life Indoor Quick Guide - Manual

Quick Set Up Guide
Xtreme Life™ DVR Indoor full manual locate on included CD
 Take unit from box, remove battery and charge Battery fully.
 Insert micro SD Card in SD Card slot.
 Turn on the battery pack by pressing the round button on the battery pack.
 Connect the provided video cable to a monitor or TV video input jack (this is for viewing the video and set
up menu).
 If Screen shows “NO SD” make sure SD card is inserted correctly and reformat the SD Card. (see pg 8 in
user manual)
 Default Recording setting is motion detection 24x7. Once the device recognizes the SD card and power is
turn on the DVR will begin to record based on motion. To change recording settings see pg 8 of user man-
ual.
**Special Note about PIR (Passive Infrared) Technology**
Each Xtreme Life™ DVR has a built in PIR sensor that detects levels of infrared radiation this is what makes
the battery life so long. Everything emits some level of radiation. The hotter an object is the more radiation it
emits. When there is a change in radiation levels this is considered motion the DVR will turn on and begin to
record. The PIR sensor does not need very much power to detect radiation so the DVR’s power will be off
even though the PIR sensor is still detecting radiation. When the PIR detects a change in radiation the DVR
will turn on and begin to record. The DVR takes approximately 3 seconds to turn on and start recording.
E0117
Quick Set Up Guide
Xtreme Life™ DVR Indoor full manual locate on included CD
 Take unit from box, remove battery and charge Battery fully.
 Insert micro SD Card in SD Card slot.
 Turn on the battery pack by pressing the round button on the battery pack.
 Connect the provided video cable to a monitor or TV video input jack (this is for viewing the video and set
up menu).
 If Screen shows “NO SD” make sure SD card is inserted correctly and reformat the SD Card. (see pg 8 in
user manual)
 Default Recording setting is motion detection 24x7. Once the device recognizes the SD card and power is
turn on the DVR will begin to record based on motion. To change recording settings see pg 8 of user man-
ual.
**Special Note about PIR (Passive Infrared) Technology**
Each Xtreme Life™ DVR has a built in PIR sensor that detects levels of infrared radiation this is what makes
the battery life so long. Everything emits some level of radiation. The hotter an object is the more radiation it
emits. When there is a change in radiation levels this is considered motion the DVR will turn on and begin to
record. The PIR sensor does not need very much power to detect radiation so the DVR’s power will be off
even though the PIR sensor is still detecting radiation. When the PIR detects a change in radiation the DVR
will turn on and begin to record. The DVR takes approximately 3 seconds to turn on and start recording.
E0117