SINGER PERFECT FINISH - Manual (Page 7)

12 13
Unplug the iron. •
hold the iron horizontally over a sink with the soleplate pointing away from •
the body and press and hold the Self-Clean Button. Steam and hot water will
drain from from the soleplate holes, washing away the scales and minerals
that have built up inside the steam chamber.
gently move the iron back and forth until the water tank is empty. •
When self-cleaning is complete, release the Self-Clean Button. •
Place iron on its heel and let it cool completely. •
Carefully wipe all water from the soleplate with an old towel, as the water and •
minerals may leave stains.
NOTE: Before using the iron after self-cleaning, test the steam and burst of
steam on an old towel or cloth that can be discarded.
Self-Clean Button
Emptying and Storing
move the variable Steam Control Dial to position. •
Unplug the iron. •
Place the iron on its heel and allow to cool completely. •
empty water from the iron before storing. •
To protect the soleplate, store the iron on its heel. •
Cleaning the Soleplate
In normal use, a coating may build up on the soleplate from starch, detergent
or burnt synthetic fibers. This can be easily removed by using a quality iron
soleplate cleaner.
When the iron is cold and unplugged, the iron can be cleaned with a damp cloth
and wiped dry.
NOTE: Never use abrasive household cleaners or other chemical agents to
clean the iron.
Never use sharp or rough objects to remove deposits on the soleplate.
TROublEShOOTING
PrOBLem reASON & SOLUTION
Iron does not heat
The iron is not properly plugged in •
The temperature setting is too low – set the temperature •
to a higher setting
Auto-Off has been engaged – move or shake the iron
•
gently to de-activate Auto-Off
No steam or not enough
steam
The water tank may be low or empty – add water •
The iron is not set to steam setting – for maximum steam, •
temperature should be on MAX
variable Steam is set too low – turn the variable Steam •
Control Dial to the position.
Iron is emitting small
particles or odor
This is normal – follow instructions for first time use •
Water may need to be changed •
Buildup of mineral deposits inside steam chamber – see •
Self-Cleaning section
Iron is dripping water
from steam vents
Overfilled – do not fill past the mAX line on water tank •
The iron may not be hot enough – set the temperature •
to MAX
Overuse of Burst of Steam – allow more time between •
bursts
If troubleshooting does not solve the problem, please call SINger at
1-800-4-SINger or 1-800-474-6437.