SINGER 7412 - Manual (Page 3)

3
For European version
Sensor for thread breakage or incorrectly threaded
condition
If needle thread breaks or is incorrectly threaded, the machine
will stop running and a beep sound generated.
Depress the foot control to check if the same phenomenon
occurs again. If so, check threaded condition or re-thread the
machine.
Information on safety devices
Other safety device
Thermal cut-off fuse is used with this machine to prevent the
motor from overheating. It may stop running, if it is sewn at low
speed for a long time.
If it should stop running during sewing, turn off the machine and
wait for a while. Then turn on the machine to re-start to sew.
Dimensions: 376 mm × 197 mm × 301 mm
Mass of the equipment: 6.92 kg
Rated Voltage: 230V ~
Rated Frequency: 50Hz
Rated input: 65W
Rated ambient temperature: 15 - 35°C
Acoustic noise level: less than 70db(A)
1. KNOWING YOUR SEWING MACHINE
Machine identification -------------------------------------------------6 - 7
Accessories -------------------------------------------------------------8 - 9
Setting up your machine ------------------------------------------10 - 11
Spool pins------------------------------------------------------------ 12 - 13
Presser foot lifter, Darning plate ------------------------------- 12 - 13
Converting to free-arm sewing -------------------------------- 12 - 13
Winding the bobbin ----------------------------------------------- 14 - 15
Threading the bobbin thread ----------------------------------- 16 - 17
Threading the top thread ---------------------------------------- 18 - 19
Using automatic needle threader --------------------------- 20 - 21
Needle, thread and fabric chart ------------------------------- 22 - 23
Adjusting top thread tension ----------------------------------- 24 - 25
Changing presser foot ------------------------------------------- 24 - 25
Control panel function ------------------------------------------- 26 - 27
Reverse operation switch ---------------------------------------- 28 - 29
2. STARTING TO SEW
Quick reference table of stitch length and width ----------- 30 - 31
Straight stitching --------------------------------------------------- 32 - 35
Keeping seams straight, Inserting zippers and piping
Hand-look quilt stitch ---------------------------------------------- 34 - 35
Zigzag stitching ----------------------------------------------------- 36 - 37
Adjusting stitch width and length, Satin stitch
Placement of patterns
TABLE OF CONTENTS
Blindhem stitch ----------------------------------------------------- 38 - 39
Multi-stitch zigzag -------------------------------------------------- 40 - 41
Stretch stitches ----------------------------------------------------- 42 - 49
Straight stretch stitch, Ric-rac stitch, Honeycomb stitch,
Overedge stitch, Feather stitch, Pin stitch, Blanket stitch,
Ladder stitch, Slant pin stitch, Slant overedge stitch,
Greek key stitch, Entredeux stitch, Double overlock stitch,
Criss-cross stitch, Crossed stitch
Decorative embroidery designs -------------------------------- 50 - 51
Ideas on design stitching
Continuous patterns ----------------------------------------------- 52 - 53
Sewing on a button ------------------------------------------------ 52 - 53
Sewing a buttonhole ---------------------------------------------- 54 - 59
Using buttonhole foot, Procedure, Corded buttonholes
3. CARING FOR YOUR MACHINE
Cleaning hook area and feed dogs ---------------------------- 60 - 61
4. OTHER INFORMATION
Satin stitch foot, Twin needle,
Straight stitch needle position ---------------------------------- 62 - 63
5. PERFORMANCE CHECKLIST ------------------------- 64 - 65