SINGER 1512 PROMISE II Instruction Manual - Manual (Page 20)

Inserting the Bobbin
When inserting or removing the bobbin, the needle must
be fully raised.
Attention:
1. Open the hinged cover.
2. Pull the bobbin case tab (a) and remove the bobbin case.
3. Hold the bobbin case with one hand. Insert the bobbin so
that the thread runs in a clockwise direction (arrow).
4. Pull the thread through the slit and under the finger. Leave
a 6 inch tail of thread.
5. Hold the bobbin case by the hinged latch.
6. Insert it into the shuttle.
Turn power switch to off ("O") before inserting or removing
the bobbin.
EN
20