SINGER 14T968DC Professional 5 Workbook Part 2 - Manual (Page 127)

BEADING FOOT
The Beading Foot is used for sewing on beads, sequins, pearls and thick cord.
Machine Preparation
• Differential Feed: Set to “N”
• Needles:
Use left needle for large beads, or right needle for smaller beads
• Upper Knife:
You may choose to work with or without the upper knife (If engaging
the knife, be careful not to cut the beads as you sew)
• Stitch Length:
Set to 3 or 4
• Foot:
Attach (snap-on) Beading Foot
Sewing Instructions
• Pull the beads along guides 1 and 2 through the back of the foot
• Raise the presser foot and place fabric under the foot, with the edge of the fabric lined up
with the edge of the Beading Foot
• Lower presser foot and begin sewing, slowly at first to make sure the beads are well posi-
tioned
Note: The needle should penetrate the fabric at 1.5mm away from the edge.
Additional Presser Feet page 4