SINGER 8780 CURVY - Manual (Page 24)

24
NEEDLE, THREAD AND FABRIC CHART
Your fabric will determine the choice of a needle and thread.
The following table is a practical guide to needle and thread
selection. Always refer to it before a new sewing project. Be
sure to use the same size and type of thread in the bobbin as
in the top thread supply.
* Do not use on stretch fabrics.
* For best sewing results, always use a Singer Branded Needle.
FABRICS THREAD NEEDLES
The fabrics below can be of any
fiber: cotton, linen, silk, wool,
synthetic, rayon, blends. They
are listed as examples of weight.
Light-
Weight
Batiste
Chiffon
Crepe
Medium-
Weight
Corduroy
Flannel
Gabardine
Gingham
Linen
Muslin
Wool Crepe
Medium-
Heavy
Bonded Wovens
Canvas
Coating
Denim
Duck
Sailcloth
Knits Bonded Knits
Double Knit
Jersey
Tricot
Cotton-wrapped
Polyester
100% Polyester
* Mercerized Size 40
* "Heavy Duty"
Cotton-wrapped
Polyester
100% Polyester
* Mercerized Size 60
Cotton-wrapped
Polyester
100% Polyester
* Mercerized Size 50
Nylon
Cotton-wrapped
Polyester
Polyester
Nylon
2020
red
shank
2020
red
shank
2020
red
shank
2045
yellow
shank
11/80
orange
band
14/90
blue
band
16/100
purple
band
18/110
yellow
band
TYPE SIZE
11/80
orange
band
14/90
blue
band
16/100
purple
band
Changing the needle
1. Raise the needle bar to its highest position by turning the
hand wheel counter clockwise.
2. Loosen the needle clamp screw by turning it counter
clockwise.
3. Remove the needle by pulling it downward.
4. Insert the new needle into the needle clamp with the flat
side toward the back.
5. Push the needle up as far as it can go.
6. Tighten the needle clamp screw with the screw driver.
Helpful Hint: Placing a scrap of fabric under the
presser foot and lowering the presser foot makes
it easier to change the needle and will preclude
dropping the needle into the needle plate slot.
NOTE: Tighten snugly, but do not over tighten.
Flat
side
toward
the
back
Flat side
Côté plat
Lado plano
Lado
plano
hacia
fuera de
Vd.
Côté
plat
orienté
vers
l’arrière
Pin
Butée
Pasador
Needle
Aiguille
Aguja
Always disconnect the machine from power
supply by removing the plug from the wall-outlet.