Mercedes-Benz E 320 Wagon 1999 Operation Manual - Manual (Page 22)

42
Synchronizing Head Restraints
If the power supply was interrupted
(battery disconnected or empty), the
power seats and head restraints are no
longer adjusted automatically.
To resynchronize the adjustment
feature, turn electronic key in steering
lock to position 2, move the seat
completely forward and the head
restraint fully down, and hold respective
buttons for approx. two seconds..
Caution!
Do not remove head restraints except
when mounting seat covers. For
removal refer to Head Restraints,
Front, see Index. Whenever restraints
have been removed be sure to reinstall
them before driving.
Memory Storing and Recalling
6 Memory button
7 Position buttons
Storing
Three sets of seat/head restraint and
exterior rear view mirror positions may
be programmed into memory. After the
seat/head restraint and exterior rear
view mirrors are positioned, push
memory button (6), release, and within
3 seconds push position button "1". A
second and third set of positions for the
same seat/head restraint and exterior
rear view mirrors can be programmed
into memory by pushing first memory
button (6) and then "2", respectively
"3".
Note:
See Index for instructions on
adjustment of mirrors.
Recalling
To recall a seat/head restraint and
exterior rear view mirror position, push
and hold position button "1", "2" or "3"
until seat/head restraint and exterior
rear view mirror movement has
stopped. The seat/head restraint and
exterior rear view mirror movement
stops when the position button is
released.
Caution!
Do not operate the power seats with
backrests in an excessively reclined
position, using the memory buttons.
Doing so could cause damage to front
or rear seats.
First move the backrest to an upright
position