Mercedes-Benz E-class 1998 Emergency Operation - Manual (Page 31)

111
Vehicle Jack
1
Jack arm
2
Jack base
The vehicle jack is stored behind the
spare wheel.
See illustration for proper storage of jack.
To remove, first remove vehicle tools and
spare wheel. Then open clamp and
remove vehicle jack.
Before storing the jack in the spare wheel
well, the jack arm must be lowered
almost to the base of the jack.
Warning!
The jack is designed exclusively for
jacking up the vehicle at the jack
tubes built into either side of the
vehicle. To help avoid personal
injury, use the jack only to lift the
vehicle during a wheel change. Never
get beneath the vehicle while it is
supported by the jack. Keep hands
and feet away from the area under
the lifted vehicle. Always firmly set
parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake
while the vehicle is raised. Be certain
that the jack is always vertical when
in use, especially on hills. Always try
to use the jack on level surface. Be
sure that the jack arm is fully
inserted in the jack tube. Always
lower the vehicle onto sufficient
capacity jackstands before working
under the vehicle.
Wheels
Replace rims or tires with the same
designation, manufacturer and type as
shown on the original part. See your
authorized Mercedes-Benz dealer for
further information.
See your authorized Mercedes-Benz
dealer for information on tested and
recommended rims and tires for
summer and winter operation. They
can also offer advice concerning tire
service and purchase.