Mercedes-Benz SLR-Class 2005 User Manual

Page 218

217

Controls in detail

Useful features

Programming or reprogramming the
integrated remote control

Step 1:

Switch on the ignition (

୴

page 40).

Step 2:

If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise press and
hold the two outer signal transmitter
buttons

2 and 4 and release them

only when the indicator lamp

1 begins

to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.

Step 3:

Hold the end of the hand-held remote
control transmitter

6 of the device

you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control
located on the interior rear view mirror,
keeping the indicator lamp

1 in view.

Step 4:

Using both hands, simultaneously
press the hand-held transmitter
button

5 and the desired integrated

signal transmitter button (

2, 3

4). Do not release the buttons until

completing step 5.

The indicator lamp

1 on the

integrated remote control will flash,
first slowly and then rapidly.

Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions:

(1) This device may not cause interfer-

ence, and

(2) this device must accept any inter-

ference received, including interfer-
ence that may cause undesired
operation of the device.

Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.

୴୴