Crimestopper Security Products CS-9704 User Manual
Page 9
9
To eliminate siren chirps, turn the ignition on and press the transmitter’s remote start button for about 3 seconds.
You will hear a short double chirp. After the ignition is turned off, there will be no siren chirps for arm, disarm and
remote start engage/reset confirmation. To revert back to siren chirps, perform the same procedure (there will
be 2 short double chirps when re-enabling chirps).
ACTIVE RE-ARM PROGRAMMING:
To disable this feature, turn the ignition on and press the transmitter’s lock button for about 3 seconds. 2 siren
chirps will sound confirming the feature has been disabled. To re-enable active rearming, perform the same
procedure (only 1 siren chirp will sound).
REMOTE START PROGRAMMING OPTIONS
The 4-position dipswitches are used to select Remote Start options as follows:
Dip
Switch
Number
Settings
#1 Tach/Tachless or Vacuum
ON = Tach/Tachless
OFF = Vacuum
#2 Crank Time (.8 or1.25 Sec.)
ON = .8 Sec.
OFF = 1.25 Sec.
#3
Gas
/
Diesel
ON
=
Gas
OFF
=
Diesel
#4 Engine or Tachless Monitor
ON = Tachless
OFF = Engine Monitor
TACH/TACHLESS MODE:
In Tach/Tachless Mode, the selection of dip switch #4 determines if the system will be monitoring the gray Engine
monitor wire or if no wire will be used (Tachless Mode).
VACUUM MODE:
In Vacuum Mode (switch #1 off), connect the Yellow Vacuum Monitor wire to a vacuum switch (not included)
which connects to an engine vacuum hose. When there is no vacuum (engine not running), a ground will be
present and the starter will crank. When vacuum is present (engine running), the switch will activate removing the
ground.
REMOTE START PROGRAMMING OPTIONS
CRANK TIME: