Mercedes-Benz SLK-Class 2008 Owners Manual - Manual (Page 275)

274
Controls in detail
Useful features
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈ Switch on the ignition ( ୴ page 37).
̈ Press and hold the desired signal
transmitter button (
2, 3 or 4).
Do not release the button.
̈ Indicator lamp 1 will begin to flash
after 20 seconds. Without releasing
the signal transmitter button, proceed
with programming starting with step 3.
Operation of integrated remote control
̈ Switch on the ignition ( ୴ page 37).
̈ Select and press the appropriate inte-
grated signal transmitter button (
2,
3 or 4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
̈ Switch on the ignition ( ୴ page 37).
̈ Simultaneously press and hold outer
signal transmitter buttons
2 and 4,
for approximately 20 seconds, until
indicator lamp
1 flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.
i If you sell your vehicle, erase the codes of all
three channels.