Hazard warning flasher, Headlamp cleaning system, Controls in detail – Mercedes-Benz SLK-Class 2011 Owners Manual User Manual
Page 76: Lighting
To signal minor directional changes:
X
Press the combination switch only to the
point of resistance in direction of
arrow ; or ? and release.
The corresponding turn signal lamps will
flash three times.
High beam
X
Turn the exterior lamp switch to position
L (
X
Switching on: Push the combination
switch in direction of arrow :.
The high-beam headlamp indicator lamp
K in the instrument cluster comes on.
X
Switching off: Pull the combination switch
in direction of arrow = to its original
position.
i
Also note the information on high-beam
headlamps with activated automatic
headlamp mode (
page 71) or the daytime
High-beam flasher
X
Switching on: Pull the combination switch
briefly in direction of arrow =.
The hazard warning flasher can be switched
on at all times, even with the SmartKey
removed from the starter switch.
The hazard warning flasher comes on
automatically when an air bag deploys.
X
Switching on: Press hazard warning
flasher switch :.
All turn signal lamps are flashing.
i
With the hazard warning flasher activated
and the combination switch set for either
left or right turn, only the respective left or
right turn signals will operate when the
ignition is switched on.
X
Switching off: Press hazard warning
flasher switch : again.
i
If the hazard warning flasher has been
activated automatically, press hazard
warning flasher switch : to switch it off.
The headlamps will be cleaned with a high-
pressure water jet automatically when the
engine is running and you have
R
switched on the headlamps
and
R
the windshield wipers have wiped the
windshield with washer fluid five times
The counter resets when you switch off the
headlamps.
For information on filling up the washer
reservoir, see “Washer system and headlamp
cleaning system” (
74
Lighting
Controls in detail
171_AKB; 3; 60, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-11T16:00:23+02:00 - Seite 74