Lifesmart LS-IQH-63 - Manual (Page 8)

8
PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120 V, 60 Hz power outlet. Only
operate heater in upright position.
Please note that infrared heaters do not heat like a traditional space heater. You should not expect
infrared heaters to blow hot air like a traditional space heater. Infrared heaters heat objects not air.
Infrared heaters are intended to supplement an already heated, insulated room. Square footage
specifications assume a single enclosed room not an entire home. Infrared heaters do not heat
through walls, floors, and are not intended to replace a main heat source. Infrared heat can take at
least 24 hours to warm a room but operate much more efficiently to maintain the desired temperature.
Infrared heaters will not work well in uninsulated unheated spaces like screened in porches, RV’s,
garages, unheated basements, etc.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The heater does not
turn on. 1. The power cord is not plugged in.
2. The electricity at the main fuse box is
not working.
3. The thermostat on the heater is set
lower than the room temperature.
1. Plug the power cord into an electrical outlet.
2. Check the electricity at the main fuse box.
3. Increase the thermostat temperature on the
heater for a higher heat setting.
There is no heat 1. The unit is in Fan Only mode.
2. The temperature needs to be increased
on the heater.
1. Turn the Mode knob to one of the two heat
settings 1 (500 W), or 2 (1,000 W).
2. Turn the Thermostat Control Knob clockwise
until you hear a click.
If the unit shuts down 1. There was a power outage.
2. The unit overheat.
1. Turn MODE to OFF and Thermostat to HI.
2. Unplug the unit and wait 5-10 minutes, then
plug in and turn MODE to ON.