Kontron CP3-SVE-M120DC - Manual (Page 6)

PD01: CP3-SVE-M120DC CPCI Power Supply
Page 6 © 2002 PEP Modular Computers GmbH RID 24139 PD02, Rev. 01
2.3 Installation
Thanks to its plug-in compatibility this DIN M-type power supply unit allows for an easy instal-
lation, by which the power supply unit’s male DIN M24/8 power connector is inserted into the
backplane’s mating female connector without the need of any intermediate adaptation.
2.4 Electrical Specifications
Input
Output
Warning!
To ensure a safe 5V operation of your equipment it is necessary that
on the backplane 5VL is connected to 5VF and 0VL to 0VF. PEP sys-
tems provide this configuration by default.
The maximum voltage compensation is 0.25V per line.
Input voltage ranges 8.5V..36V DC
Efficiency Typ. 80%
Input current limitation
Typ.
≤
35A
peak
(cold state)
Typ.
≤
60A
peak
(hot state)
Fuse 25A
Adjustment range V
o1
, V
o2
± 5%
Status indication Green LED’s for V
o1
, V
o2
, V
o3
, V
o4
Ripple V
o1
, V
o2
< 50mV
pp
,
V
o3
, V
o4
< 30mV
pp
Noise voltage Typ. 50mV
pp
(band width 20MHz)
Temperature coefficient 0.025% / K
Switch on / switch off performance No overshooting of V
o
(soft-start)
Rise-delay time < 0.5s
Run-up time
≤
50ms