Kontron AM5020 uEFI BIOS - Manual (Page 28)

Boot Setup AM5020 uEFI BIOS
Page 22 ID 1045-0247, Rev. 1.0
P R E L I M I N A R Y
3.1.2 Fast Boot
This function is used to enable or disable boot with initialization of a minimal set of devices re-
quired to launch active boot option..
Default setting: Disabled
3.1.3 uEFI Boot
This function is used to enable or disable uEFI boot from disks.
Default setting: Enabled
3.1.4 Setup Prompt Timeout
This integer function is used to set an additional time the POST should wait for the operator to
press the key to enter setup. The time is entered in seconds.
Default setting: 2
3.1.5 Bootup NumLock State
This function is used to set the state of the keyboard’s numlock function after POST.
Default setting: On
3.1.6 CSM16 Module Version
This function provides display-only information concerning the CSM Module and is intended for
internal use only.
SETTING DESCRIPTION
Disabled Use this setting to disable fast boot.
Enabled Use this setting to enable fast boot.
SETTING DESCRIPTION
Disabled Use this setting to prevent the system from booting native uEFI-aware operating systems
from disks.
Enabled Use this setting to enable booting of native uEFI-aware operating systems from disks, if
present, and in boot order.
SETTING DESCRIPTION
1
...
65535
Use one of these settings to specify the setup prompt timeout.
SETTING DESCRIPTION
On Use this setting to switch on the keyboard’s numlock function after POST.
Off Use this setting to switch off the keyboard’s numlock function after POST.