Kontron AM5500 - Manual (Page 19)

AM5500 Introduction
ID 1030-9305, Rev. 2.0 Page 1 - 7
P R E L I M I N A R Y
1.4 Technical Specification
Table 1-2: AM5500 Main Specifications
FEATURES SPECIFICATIONS
AMC Inter- conne
ction
Serial ATA Common Options Region ports 2-3
• Two Serial ATA ports
Co
nnectors
Onboard Connectors • Two 22-pin SATA connectors, J3 and J5
• One 10-pin programming connector, J4, (RS-232 serial port)
AMC Card-edge
Connector • One 170-pin AMC Card-edge connector
LEDs
Module Management
LEDs • LED1 (red): Out-of-Service LED
• LED2 (red/green/amber): Health LED
• HS LED (blue): Hot Swap LED
IPMI
Module Management
Controller • The MMC carries out IPMI commands such as monitoring onboard tem-
perature conditions, board voltages and the power supply status, and
managing hot swap operations.
• The MMC is accessible via a local IPMB (IPMB-L).
Hot Swap The AM5500 has full hot swap capability.
Thermal Management Two board temperature sensors
General
Power Consumption Management power: approx. 0.3 W
Payload power:
approx. 0.5 W (without HDD/SSD device)
Temperature Range Operational: -5 °C to +75 °C
Storage: -40 °C to +70 °C
Mechanical Double, Mid-size AMC form factor
Dimensions 181.5 mm x 147.0 mm x 18.96 mm
Board Weight 140 grams (without HDD/SSD)
Software
Software IPMI Module Management Controller Firmware providing the following features:
• Board supervision
• The MMC is accessible via IPMB-L
• The MMC Firmware can be updated in the field
Note ...
When SATA HDDs/SSDs are installed, refer to their operational
specifications as this will influence the operational and storage
temperature of the AM5500.