Introduction cp3003-sa – Kontron CP3003-V User Manual
Page 30
Introduction
CP3003-SA
Page 1 - 10
ID 1052-6929, Rev. 2.0
D R A F T — F O R I N T E R N A L U S E O N L Y
Inte
grated
Controller
Graphics Controller
High-performance 3D graphics controller integrated in the processor:
•
Dynamic Video Memory Technology (DVMT)
•
Supports digital displays with resolutions up to 2560 x 1600 pixels @
60 Hz through DisplayPort or up to 1920x1200 pixels @ 60Hz using
HDMI/DVI. HDMI/DVI displays are supported via an appropriate
adapter. Refer to Chapter 2.11.4, Table 2-8 for further information on
the display configuration options.
•
Supports analog display with resolutions up to 2048 x 1536 pixels @
75 Hz for VGA displays
Interfaces
CompactPCI
Compliant with CompactPCI Specification PICMG® 2.0 R 3.0:
•
System master operation
•
32-bit / 33 MHz master interface (66 MHz on request)
•
3.3 V or 5 V (universal PCI interface)
•
Support for up to seven peripheral slots (7x REQ/GNT signals)
When installed in a peripheral slot, the CP3003-SA is isolated from the Com-
pactPCI bus. It receives power from the backplane and supports rear I/O.
CP3003-SA removal under power:
When installed in a peripheral slot, the CP3003-SA supports hot plugging
on the power interface through a dedicated power controller, but not on the
PCI interface.
Hot swapping of peripheral boards controlled by the CP3003-SA:
When installed in the system controller slot, the CP3003-SA supports the hot
swapping of other boards. Individual clocks for each slot and Enum signal
handling are in compliance with the PICMG 2.1 Hot Swap Specification.
The CP3003-SA itself, however, is not hot swappable. When installed in the
system controller slot, the system must be powered down in order to replace
the board.
Rear I/O
The following interfaces are routed to the rear I/O connector J2:
•
COMA and COMB, or COMA and GPIO (all ports have 3.3V LVTTL sig-
naling)
•
2 x USB 2.0
•
VGA (analog)
•
2x Gigabit Ethernet
•
2x SATA 3Gb/s
•
System management signals
•
Input for 5V standby power
•
General purpose signals
Table 1-1:
CP3003-SA Main Specifications (Continued)
FEATURES
SPECIFICATIONS