Koala Kare KB108 - Manual (Page 3)

Step 1.
Remove the station from the shipping container and check for any freight damage. Identify the
best location for installing the unit. Hold the unit in place and open the bed. Make sure you
have taken the operating clearance into
consideration.
Step 2.
Determine the best method of mounting
based on the type of wall. You may have to
purchase toggles.
Step 3.
The oval unit has four mounting holes
provided in the back wall, positioned on a
16” (406 mm) stud center. If possible, locate
the wood or metal studs for fastening the
unit in the desired location. If the walls do
not have studs on center as outlined, make
sure at least one side of the unit is installed
into the stud. Use toggles for holes on the
opposite side.
Step 4.
Find the stud where you will be attaching the left side of the unit to the wall. Measure up from the
floor 46” (1,168 mm), at the center of the stud, and mark the wall. Mark remaining holes using a
measuring tape to make sure the holes are precisely positioned. Hold unit in place to verify. Use
four ¼” x 3” panhead wood screws with washers (supplied) to secure the unit to the studs.
If the wall surface is masonry or tile over studs, use a 7/32” masonry drill bit for the pilot hole until
you hit the stud. Change bit to 1/8” regular drill bit. Use four ¼” x 3” panhead wood screws with
washers (supplied).
If the wall has wood studs that are not on 16” (406 mm) centers, has metal studs or an underlying
surface of concrete block, drill with a ½” masonry bit. (You may have to purchase toggles before
installing.) You must allow a minimum of inside wall space for toggles to turn depending on
toggles used. Insert and tighten toggles.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in dispenser with
sanitary bed liners. Replacement parts and additional liners can be purchased from your local
distributor or by calling toll free 888.733.3456 or 303.539.8300.
Baby Bear Baby Changing Station
Model Number KB108
INSTALLATION INSTRUCTIONS