Cary Audio Design SLP-88 - Manual (Page 5)

Cary Audio Design SLP-88 Preamplifier Operations Manual
- 5 -
INSTALLATION AND UNPACKING
WARNING
MAKE NO ATTEMPT TO PUT THE SLP-88 PREAMPLIFIER IN SERVICE
WITH THE COVER OFF THE UNIT. CONTACT WITH AC VOLTAGE
INSIDE THE SLP-88 CAN BE FATAL!
All our shipping cartons have been especially designed to protect their contents and
special care has been taken to prevent damage under normal conditions. Mishandling
should be evident upon inspection of the shipping container. If damage is found after
visual inspection, do not destroy the evidence. If necessary, document the damage with
photographs and contact the transport carrier immediately.
Carefully remove your new SLP-88 from its packing carton and examine it closely for
signs of shipping damage. It is recommended to save all original packing cartons to
protect your preamplifier should you wish to store it or ship it for after-sales service.
WARRANTY CARD
If you are the original USA purchaser of this preamplifier and purchased it for use within
the United States, you should fill out the enclosed warranty registration card and return
it to Cary Audio Design, within 10 days of your purchase. Warranty restrictions and
applications may apply. Consult the warranty section of this manual. Export models are
covered by local warranties assigned by your local Cary Audio distributor.
SLP-88 PLACEMENT
The SLP-88 is designed for use inside of homes. It must be protected from the elements
and temperature extremes. For example, avoid placing the unit in extremely hot
locations such as near or on top of radiators or other home heating devices. Its location
among the user’s home audio components is not critical.
POWER REQUIREMENTS
The SLP-88 is designed to operate from AC house current mains. The design voltage is
120 Volts AC at 50/60 Hz. Export units have settings for 100/200/220/240 Volts AC at
50/60 Hz.