Just Better Changing to 115 Volts on the Emerson Dual Voltage Motor - Manual

How to Change to 115 Volts on the Emerson
Dual Voltage Motor (JB DV-XXX-250 Pumps
Only)
The JB Industries Dual Voltage Pump is set up from the factory for high voltage (230 Volts). Follow the
instructions below to change the motor for low voltage (115 volts) applications. This only applies to
Emerson Motors with this switch plate- for other motors, contact JB Technical Service.
Step 1. Unplug Motor for outlet. Remove the motor switch on
the back of the Bell Housing to reveal the Switch Plate.
Step 2. Remove the White Wire from terminal #3 and
connect to terminal #4 (Both White Wires will be together).
Step 3. Remove the Brown Wire from holder #6 and
connect to terminal #3.
Notes: Motor switch wires remain in the same position for both
high and low voltage. #6 is a holder for the Brown Wire when
the motor is set up for high voltage.
© 2007 J/B Industries, Inc.
JB Industries
Aurora, IL 60505
www.jbind.com
Technical Assistance
800-323-0811