Jeep 2015 Patriot - User Guide - Manual (Page 74)

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
HomeLink ® replaces up to three hand-held transmitters that operate devices such as
garage door openers, motorized gates, lighting or home security systems. The
HomeLink
® unit is powered by your vehicles 12 Volt battery.
The HomeLink ® buttons that are located in the overhead console or sunvisor
designate the three different HomeLink ® channels.
The HomeLink ® indicator is located above the center button.
Before You Begin Programming
HomeLink®
Ensure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new battery
be placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink
® system.
To erase the channels, place the ignition
switch into the ON/RUN position, then
push
and hold the two outside
HomeLink ® buttons (I and III) for up to
20 seconds or until the red indicator
flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
® for
the first time. Do not erase channels when programming additional buttons.
If you have any problems, or require assistance, please call toll-free
1-800-355-3515 or, on the Internet at HomeLink.com for information or assistance.
HomeLink® Buttons
1 — HomeLink ® Channels
ELECTRONICS
72