Jeep 2015 Patriot - User Guide - Manual (Page 67)

• This downloaded phonebook cannot be edited or deleted on the Uconnect ®
Phone. These can only be edited on the mobile phone. The changes are transferred
and updated to Uconnect
® Phone on the next phone connection.
Making A Phone Call
• Push the “Phone” button .
• After the BEEP, say “dial” (or “call” a name).
• After the BEEP, say number (or name).
Receiving A Call — Accept (And End)
• When an incoming call rings/is announced on Uconnect ® , push the “Phone”
button .
• To end a call, push the “Phone” button .
Mute (Or Unmute) Microphone During Call
• During a call, push the “Voice Command” button .
• After the BEEP, say “mute” (or “mute off”).
Transfer Ongoing Call Between Handset And Vehicle
• During a call, push the “Voice Command” button .
• After the BEEP, say “transfer call.”
Changing The Volume
• Start a dialogue by pushing the “Phone” button , then adjust the volume
during a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable
level while the Uconnect ® system is speaking. Please note the volume setting for
Uconnect ® is different than the audio system.
WARNING!
• Any voice commanded system should be used only in safe driving conditions
following applicable laws regarding phone use. Your attention should be
focused on safely operating the vehicle. Failure to do so may result in a
collision causing you and others to be severely injured or killed.
• In an emergency, to use Uconnect ® Phone, your mobile phone must be:
• turned on
• paired to Uconnect
® Phone
• have network coverage
ELECTRONICS
65