beautypg.com

Enabling and disabling parksense, Service the parksense® park assist system – Jeep 2015 Grand Cherokee SRT - Owner Manual User Manual

Page 237

background image

Adjustable Chime Volume Settings
Front and Rear chime volume settings can be selected

from the Uconnect® System. Refer to ЉUconnect® Set-

tings” in “Understanding Your Instrument Panel” for

further information.
The chime volume settings include LOW, MEDIUM, and

HIGH. The factory default volume setting is MEDIUM.
ParkSense® will retain its last known configuration state

through ignition cycles.

Enabling And Disabling ParkSense®

ParkSense® can be enabled and disabled with the

ParkSense® switch.

When the ParkSense® switch is pressed to

disable the system, the instrument cluster will

display the “PARKSENSE OFF” message for

approximately five seconds. Refer to “Driver

Information Display (DID)” in “Understanding Your

Instrument Panel” for further information. When the

shift lever/gear selector is moved to REVERSE and the

system is disabled, the DID will display the

“PARKSENSE OFF” message for as long as the vehicle is

in REVERSE.
The ParkSense® switch LED will be ON when

ParkSense® is disabled or requires service. The

ParkSense® switch LED will be OFF when the system is

enabled. If the ParkSense® switch is pressed, and the

system requires service, the ParkSense® switch LED will

blink momentarily, and then the LED will be ON.

Service The ParkSense® Park Assist System

During vehicle start up, when the ParkSense® System

has detected a faulted condition, the instrument cluster

will actuate a single chime, once per ignition cycle, and it

will display the ЉPARKSENSE UNAVAILABLE WIPE

REAR SENSORSЉ, ЉPARKSENSE UNAVAILABLE WIPE

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 235