Jeep 2010 Wrangler Unlimited - Owner Manual - Manual (Page 93)

The following are general phone to Uconnect™ Phone
pairing instructions:
• Press the button to begin.
• After the ЉReadyЉ prompt and the following beep, say
ЉSetup Phone Pairing.Љ
• When prompted, after the beep, say ЉPair a PhoneЉ and
follow the audible prompts.
• You will be asked to say a four-digit Personal Identi-
fication Number (PIN), which you will later need to
enter into your cellular phone. You can enter any
four-digit PIN. You will not need to remember this PIN
after the initial pairing process.
• For identification purposes, you will be prompted to
give the Uconnect™ Phone a name for your cellular
phone. Each cellular phone that is paired should be
given a unique phone name.
• You will then be asked to give your cellular phone a
priority level between one and seven, with one being
the highest priority. You can pair up to seven cellular
phones to your Uconnect™ Phone. However, at any
given time, only one cellular phone can be in use,
connected to your Uconnect™ System. The priority
allows the Uconnect™ Phone to know which cellular
phone to use if multiple cellular phones are in the
vehicle at the same time. For example, if priority three
and priority five phones are present in the vehicle, the
Uconnect™ Phone will use the priority three cellular
phone when you make a call. You can select to use a
lower priority cellular phone at any time (refer to
ЉAdvanced Phone ConnectivityЉ in this section).
Dial by Saying a Number
• Press the button to begin.
• After the ЉReadyЉ prompt and the following beep, say
ЉDial.Љ
92 UNDERSTANDING THE FEATURES OF YOUR VEHICLE