Jeep 2010 Wrangler Unlimited - Owner Manual - Manual (Page 160)

d. Screw the pivot screws back into place using a #T30
Torx
௡ head driver. Secure them until they are snug,
being careful not to cross-thread the screws or over-
tighten.
CAUTION!
Do not overtighten the screws. You can strip the
screws if they are overtightened.
5. Remove the swing gate bar (black metal bar for
bottom of rear window) and set aside.
NOTE: Be sure the wire harness in the left rear corner is
not tangled in the soft top bows before you lift the top.
6. Unsnap and remove the black boot cover. This cover
should be discarded. It was intended as a protective
cover for shipping only.
NOTE: A visual instruction sheet is enclosed in the dual
top wrap.
7. Put up the soft top. Refer to “Soft Top — Putting Up
the Soft Top” in this section.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 159