beautypg.com

Power outlet, Uconnect™ phone, Phone pairing – Jeep 2010 Patriot - User Guide User Manual

Page 36: Electronics

background image

POWER OUTLET

• The power outlet is located on the instrument panel below the climate control and is

powered when the ignition switch is in the ON position.

• The outlet can operate a conventional cigar lighter unit or power accessories designed

for use with a standard power outlet adapter.

NOTE: Do not exceed the maximum power of 160 Watts (13 Amps) at 12 Volts. If the 160
Watt (13 Amp) power rating is exceeded the fuse protecting the system will need to be
replaced.

Uconnect™ Phone

• The Uconnect™ Phone is a voice-activated, hands-free, in-vehicle communications

system.

• The Uconnect™ Phone allows you to dial a phone number with your cellular phone using

simple voice commands.

• For vehicles equipped with Video Entertainment System (VES)™, refer to the Uconnect™

Phone section of the Uconnect™ User's Manual on the DVD for further details.

• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the DVD

for further details.

WARNING!

• Any voice commanded system should be used only in safe driving conditions

following local laws and phone use. All attention should be kept on the roadway

ahead. Failure to do so may result in an accident causing serious injury or death.

• Your phone must be turned on and paired to the Uconnect™ Phone to allow use of

this vehicle feature in emergency situations, when the cellular phone has network

coverage and stays paired to the Uconnect™ Phone.

NOTE: The Uconnect™ Phone requires a cellular phone equipped with the Bluetooth®
Hands-Free Profile, Version 0.96 or higher. For Uconnect™ customer support, call
1–877–855–8400.

Phone Pairing

NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth® instructions in your cell phone user guide to complete the phone
pairing setup.

• Press the Phone button

to begin.

• Wait for the “ready” prompt and beep.

• (After the BEEP), say “Uconnect setup”.

• (After the BEEP), say “phone pairing”.

• (After the BEEP), say “pair a phone”.

• Follow the audible prompts.

ELECTRONICS

34