Jeep 2010 Liberty - Owner Manual - Manual (Page 187)

Sky Slider™ Control
The Sky Slider™ switch is located between the sun visors
on the overhead console.
NOTE: The Sky Slider™ switch will operate when the
ignition switch is turned to the ON or ACC position.
Opening the Sky Slider™
Using Automatic Mode
Press the switch rearward and release it within one-half
second and the Sky Slider™ will open from the front and
move automatically toward the rear of the vehicle.
Press the switch forward and release it within one-half
second and the Sky Slider™ will open from the rear and
move automatically toward the front of the vehicle.
NOTE:
• During operation, any movement of the Sky Slider™
switch will stop the Sky Slider™ roof.
• To resume the operation from a partially open posi-
tion, press and release the switch a second time.
• The Sky Slider™ will not open from the front and the
rear at the same time. The Sky Slider™ must close fully
before opening it from the opposite end.
Sky Slider™ Switch
186 UNDERSTANDING THE FEATURES OF YOUR VEHICLE