beautypg.com

Malfunction indicator light (mil), Charging system light, Oil pressure warning light – Jeep 2010 Compass - User Guide User Manual

Page 45: Anti-lock brake (abs) light, Electronic throttle control (etc) light, What to do in emergencies

background image

WARNING!

Driving a vehicle with the red brake light on is dangerous. Part of the brake system

may have failed. It will take longer to stop the vehicle. You could have an accident.

Have the vehicle checked immediately.

- Malfunction Indicator Light (MIL)

• Certain conditions, such as a loose or missing gas cap, poor fuel quality, etc., may

illuminate the MIL after engine start. The vehicle should be serviced if the light stays on
through several typical driving cycles. In most situations, the vehicle will drive normally
and not require towing.

• If the MIL flashes when the engine is running, serious conditions may exist that could

lead to immediate loss of power or severe catalytic converter damage. We recommend
you do not operate the vehicle. Have the vehicle serviced immediately.

- Charging System Light

• This light shows the status of the electrical charging system. If the charging system light

remains on, it means that the vehicle is experiencing a problem with the charging
system.

• We recommend you do not continue driving if the charging system light is on. Have the

vehicle serviced immediately.

- Oil Pressure Warning Light

• This light indicates low engine oil pressure. If the light turns on while driving, stop the

vehicle and shut off the engine as soon as possible. A chime will sound for four minutes
when this light turns on.

• We recommend you do not operate the vehicle or engine damage will occur. Have the

vehicle serviced immediately.

- Anti-Lock Brake (ABS) Light

• This light monitors the Anti-Lock Brake System (ABS).

• If the light is not on during starting, stays on, or turns on while driving, we recommend

you drive to the nearest service center and have the vehicle serviced immediately.

- Electronic Throttle Control (ETC) Light

• This light informs you of a problem with the Electronic Throttle Control (ETC) system.

• If a problem is detected, the light will come on while the engine is running. Cycle the

ignition when the vehicle has completely stopped and the shift lever is placed in the
PARK position; the light should turn off.

• If the light remains lit with the engine running, your vehicle will usually be drivable;

however, see an authorized service center immediately. If the light is flashing when the
engine is running, immediate service is required and you may experience reduced
performance, an elevated/rough idle or engine stall and your vehicle may require towing.

43

WHAT TO DO IN EMERGENCIES