Jeep 2009 Liberty - Quick Reference Guide - Manual (Page 4)

vehicle features
wiper/waSher lever:
front WiPers
intermittent, Low and high operation
• Rotate the end of the lever to the first detent position for one of five
intermittent settings, the second detent for low wiper operation and the
third detent for high wiper operation.
mist
• Pull down on the lever and release when a single wipe is desired.
Washer operation
• Pull the lever towards you and hold for as long as spray is desired.
rain sensing Wipers
• This feature senses moisture on the vehicle’s windshield and
automatically activates the wipers for the driver when the switch is in
the intermittent positions. Refer to Owner’s Manual for operation.
rear WiPer
Wiper operation
• Rotate the center portion of the lever forward to the first detent for rear
wiper operation.
Washer operation
• Rotate the center portion of the lever past the first detent to activate the
rear washer.
Speed conTrol lever:
crUise on/off
• Push the ON/OFF button to activate the Speed Control.
• CRUISE will appear on the instrument cluster to indicate the Speed
Control is on.
• Push the ON/OFF button a second time to turn the system off.
set
• With Speed Control on, press down and release the lever to set a
desired speed.
acceL/deceL
• Press and hold the lever up to accelerate or down to decelerate the
vehicle; release the lever to save the new set speed.
• Once a speed is set, tapping the lever up or down will increase or
decrease the set speed approximately 1 mph (2 km/h).
canceL
• Pull the lever toward you, or apply the brakes to cancel the set speed
and maintain the set speed memory.
• Push the ON/OFF button to turn the system off and erase the set
speed memory.
resUme
• To resume a previously selected speed in memory, push the lever
up and release.
front washer
(pull toward
driver)
front wipers rear wiper/washer
mist (down)
push on/off
button